Si281312E Procedure to Remove Decoration PanelRemoval Procedure 32. Procedure to Remove Decoration PanelProcedure Warning Be sure to wait for 10 minutes or more after turning off all powersupplies before disassembling work.Step Procedure Points Removing the suctiongrille according toprocedure for removingthe suction grille. Relay connector Corner cover string Screw fixing the decorationpanel According to theprocedure for the removalof PCB, remove the lidfrom the switch box anddisconnect the relayconnector for the swingmotor.1. Removing the decorationpanel1 Pull down the cornercovers on the inner side(i.e., the suction grilleside) to remove them.2 Remove the cornercover strings.3 Unfasten the 4 screwsthat fix the decorationpanel to the extent thatthe panel is looselyfixed.4 Unlatch the 4 outerlatches (A).(At this time, make surethe 2 inner latches (B)are latched.)5 While holding thedecoration panel withboth hands, unlatch the2 inner latches (B), andthen remove thedecoration panel.Corner coverCorner coverMounting screwsMountingscrewsHookOuter latch (A)(located in 4 places)HookInner latch (B)(located in 2 places)Relay connectorString Corner coverLatchMounting screwsHook