Daikin FDXS25F2VEB Installation Manual

Also see for FDXS25F2VEB: Operation manual Installation manual

Contents

Daikin FDXS25F2VEB Installation Manual Manual pdf 13 page image

English 10WIRINGSee the installation manual supplied with the outdoor unit. HOW TO CONNECT WIRINGS.• Wire only after removing the control box lid as shown in the Fig.Caution• When clamping the wiring, use the included clamping material as shown in the Fig. to prevent outside pressure being exertedon the wiring connections and clamp firmly.• When doing the wiring, make sure the wiring is neat and does not cause the control box lid to stick up, then close the coverfirmly. When attaching the control box lid, make sure you do not pinch any wires.• Outside the machine, separate the weak wiring (remote controller wiring) and strong wiring (earth wire and power supply wiring) at least50mm so that they do not pass through the same place together. Proximity may cause electrical interference, malfunctions, and breakage.[ PRECAUTION ]• See also the “Electrical Wiring Diagram Nameplate” when wiring the unit for electrical power.[ Connecting electrical wiring ]• Power supply wiring and Earth wireRemove the control box lid.Next, pull the wires into the unit through the wiring throughhole and connect to the power wiring terminal block (4P).Be sure to put the part of the sheathed vinyl into the controlbox.• Make sure to let a wire go through a wire penetration area.• After wiring, seal the wire and wire penetration area toprevent moisture and small creatures from the outside.• Wrap the strong and weak electric lines with the sealingmaterial as shown in the figure below.(Otherwise, moisture or small creatures such as insects fromthe outside may cause short-circuit inside the control box.)Attach securely so that there are no gaps.(Rear)Wiring DiagramControl box lidPower supply wiringEarth wire∗Remote controller wiringWiring throughholeSealing material(accessory)Wire[How to adhere it]OutsideunitInsideunitPower supply wiringEarth wireIndoor PCboard(ASSY)Clamps(for preventing slippage)*Transmission wiring*Remote controller wiring* Do not connect powersupply wiring here.That may causemalfunctionControl box Control boxPower supply wiring/Earth wire㽢䕿