Daikin FHQ18PVJU Operation Manual

Also see for SkyAir FHQ18PVJU: Service manual Service manual Service manual Engineering data Engineeiring data

Contents

Daikin FHQ18PVJU Operation Manual Manual pdf 7 page image

5 EnglishRegarding drainage of drain pipeIs the drain pipe executed to perform com-•plete drainage?If proper drainage is not carried out from theoutdoor drain pipes during air-conditioning op-eration, chances are that dust and dirt areclogged in the pipe. This may result in a waterleakage from the indoor unit. Under such circum-stances, stop the operation of the air conditioner,and then consult your dealer or our service sta-tion.NAME AND FUNCTION OF5.EACH SWITCH AND DISPLAYON THE REMOTE CONTROLLERRefer to Fig. 1 on page [1]The illustrations in this operating manual corre-spond to the remote control format BRC1C type.1ON/OFF BUTTONPress the button and the system will start.Press the button again and the system willstop.2 OPERATION LAMP (RED)The lamp lights up during operation.3DISPLAY “ ” (UNDER CENTRAL-IZED CONTROL)When this display shows, the system is UN-DER CENTRALIZED CONTROL.4DISPLAY “ ” “ ” “ ” “ ” “ ”(OPERATION MODE)This display shows the current OPERATIONMODE.5DISPLAY “ TEST ” (INSPECTION/TESTOPERATION)When the INSPECTION/TEST OPERATIONBUTTON is pressed, the display shows thesystem mode is in.6DISPLAY “ ” (PROGRAMMED TIME)This display shows the PROGRAMMEDTIME of the system start or stop.7 DISPLAY “ ” (SET TEMPERATURE)This display shows the set temperature.8 DISPLAY “ ” (FAN SPEED)This display shows the set fan speed.9 DISPLAY “ ” (AIR FLOW FLAP)Refer to “AIR FLOW DIRECTION ADJUST”.10DISPLAY “ ” (TIME TO CLEAN AIRFILTER)Refer to “HOW TO CLEAN THE AIR FILTER”.11 DISPLAY “ ” (DEFROST)Refer to “DEFROST OPERATION”.12NON-FUNCTIONING DISPLAYIf that particular function is not available,pressing the button may display the words“NOT AVAILABLE” for a few seconds.13 TIMER MODE START/STOP BUTTONRefer to “PROGRAM TIMER OPERATION”.14 TIMER ON/OFF BUTTONRefer to “PROGRAM TIMER OPERATION”.15INSPECTION/TEST OPERATION BUTTONThis button is used only by qualifi ed servicepersons for maintenance purposes.16PROGRAMMING TIME BUTTONUse this button for programming “STARTand/or STOP” time.17TEMPERATURE SETTING BUTTONUse this button for SETTING TEMPERA-TURE.18 FILTER SIGN RESET BUTTONRefer to “HOW TO CLEAN THE AIR FILTER”.19FAN SPEED CONTROL BUTTONPress this button to select the fan speed,HIGH or LOW, of your choice.20OPERATION MODE SELECTOR BUTTONPress this button to select OPERATIONMODE.21 AIR FLOW DIRECTION ADJUST BUTTONRefer to “AIR FLOW DIRECTION ADJUST”.NOTEFor the sake of explanation, all indications are•shown on the display in Fig. 1 on page [1] con-trary to actual running situations.OPERATION PROCEDURE6.Refer to Fig. 1 on page [1]To protect the unit, turn on the main power•switch 6 hours before operation.If the main power supply is turned off during•operation, operation will restart automaticallyafter the power turns back on again.