Daikin FT50GAVAL Operation Manual

Contents

Daikin FT50GAVAL Operation Manual Manual pdf 13 page image

12DisplayThen the TIMER lamp lights up.Combining ON TIMER and OFF TIMER When TIMER is set, the present time is notdisplayed. Once you set ON,OFF TIMER, the time settingis kept in the memory. (The memory is canceledwhen remote controller batteries are replaced.) When operating the unit via the ON/OFFTimer, the actual length of operation may varyfrom the time entered by the user.(Maximumapprox. 10 minutes.) A sample setting for combining the two timers is shown below.Notes on ON,OFF TIMERDisplayPresent time: 11:00 PM(The unit operating)OFF TIMER at 0:00 a.m.ON TIMER at 7:00 a.m. Combined(Example) Check that the clock is correct.If not, set the clock to the present time. (See page 8.)Timer OperationTimer functions are useful for automaticallyswitching the air conditioner on or off at night or inthe morning. You can also use OFF TIMER and ONTIMER in combination.OFF TIMER operationON TIMER operation Check that the clock is correct. If not, set theclock to the present time. (See page 8.) NIGHT SET MODEWhen the OFF TIMER is set, the airconditioner automatically adjusts thetemperature setting (0.5°C up in COOL,2.0°C down in HEAT) to prevent excessivecooling (heating) for yourpleasant sleep.PressOFF TIMERwhile the air conditioneris operating.Press CANCEL . To cancel the timer:PressOFF TIMERonce again.Then the TIMER lamp goes off.23Then the TIMER lamp lights up.is displayed.blinks.1DisplayDisplayNotes on OFF TIMERPress until the time settingreaches the point you like. Every pressing of either button increasesor decreases the time setting by 10minutes. Holding down either buttonchanges the setting rapidly.Press until the time settingreaches the point you like. Every pressing of either button increases ordecreases the time setting by 10 minutes.Holding down either button changes thesetting rapidly.Press while the air conditioneris not operating.Press once again.1Displayis displayed.blinks.23ATTENTION In the following cases, set the timer again. After a breaker has turned OFF. After a power failure. After replacing batteries in the remote controller.