SiBE04-401 Introductionvii1.1.3 Inspection after RepairBe sure to use the specified cable to connect between the indoor and outdoorunits. Make the connections securely and route the cable properly so that thereis no force pulling the cable at the connection terminals.Improper connections can cause excessive heat generation or fire.When connecting the cable between the indoor and outdoor units, make surethat the terminal cover does not lift off or dismount because of the cable.If the cover is not mounted properly, the terminal connection section can causean electrical shock, excessive heat generation or fire.Do not damage or modify the power cable.Damaged or modified power cable can cause an electrical shock or fire.Placing heavy items on the power cable, and heating or pulling the power cablecan damage the cable.Do not mix air or gas other than the specified refrigerant (R410A / R22) in therefrigerant system.If air enters the refrigerating system, an excessively high pressure results,causing equipment damage and injury.If the refrigerant gas leaks, be sure to locate the leak and repair it beforecharging the refrigerant. After charging refrigerant, make sure that there is norefrigerant leak.If the leak cannot be located and the repair work must be stopped, be sure toperform pump-down and close the service valve, to prevent the refrigerant gasfrom leaking into the room. The refrigerant gas itself is harmless, but it cangenerate toxic gases when it contacts flames, such as fan and other heaters,stoves and ranges.When replacing the coin battery in the remote controller, be sure to disposedof the old battery to prevent children from swallowing it.If a child swallows the coin battery, see a doctor immediately.WarningCautionInstallation of a leakage breaker is necessary in some cases depending on theconditions of the installation site, to prevent electrical shocks.Do not install the equipment in a place where there is a possibility ofcombustible gas leaks.If a combustible gas leaks and remains around the unit, it can cause a fire.Be sure to install the packing and seal on the installation frame properly.If the packing and seal are not installed properly, water can enter the room andwet the furniture and floor.For integral unitsonlyWarningCheck to make sure that the power cable plug is not dirty or loose, then insertthe plug into a power outlet all the way.If the plug has dust or loose connection, it can cause an electrical shock or fire.If the power cable and lead wires have scratches or deteriorated, be sure toreplace them.Damaged cable and wires can cause an electrical shock, excessive heatgeneration or fire.
