5 Outdoor Unit Indoor Unit1. Air filter2. Photocatalytic deodorizing filter orAir purifying filter:• These filters are attached to the inside of the airfilters.3. Air inlet4. Front grille5. Grille tab6. Display7. Air outlet8. Flap (horizontal blade): (page 12.)9. Louvers (vertical blades):• The Louvers are inside of the air outlet.(page 12.)10. Operation lamp (green)11. TIMER lamp (yellow): (page 14.)12. Indoor Unit ON/OFF switch:• Push this switch once to start operation.Push once again to stop it.• The operation mode refer to the following table.• This switch is useful when the remote controlleris missing.13. Room temperature sensor:• It senses the air temperature around the unit.14. Signal receiver:• It receives signals from the remote controller.• When the unit receives a signal, you will hear ashort beep.• Operation start .............beep-beep• Settings changed ..........beep• Operation stop ..............beeeeep Outdoor Unit15. Air inlet: (Back and side)16. Air outlet17. Refrigerant piping and inter-unit cable18. Drain hose19. Earth terminal:• It is inside of this cover.Appearance of the outdoor unit may differ from some models.1718191615Mode TemperaturesettingAir flowrateFTS COOL 22°C AUTOFTYS AUTO 25°C AUTO