14EnglishBasic OperationAdjusting the Airflow DirectionYou can adjust the airfl ow direction to increase your comfort.CAUTION• Always use a remote controller to adjust the angles of the fl aps and louvers.− If you attempt to move the fl aps and louvers forcibly by hand when they are swinging, the mechanism maybe damaged.− Inside the air outlet, a fan is rotating at a high speed.To start auto swingUp and down airflow directionPress �• “ ” is displayed on the LCD.• The fl aps (horizontal blades) will begin to swing.Right and left airflow directionPress �• “ ” is displayed on the LCD.• The louvers (vertical blades) will begin to swing.The 3-D airflow directionPress and �• “ ” and “ ” are displayed on the LCD.• The fl aps and louvers move in turn.• To cancel 3-D airfl ow, press either or again.The fl aps or louvers will stop moving.To set the flaps or louvers at the desired position• This function is effective while the fl aps or louvers are in auto swing mode.Press and when the flaps or louversreach the desired position�• In the 3-D airfl ow, the fl aps and louvers move in turn.• “ ” or “ ” disappears from the LCD.NOTENotes on airflow direction setting• The movable range of the fl aps varies according to the operation mode.• The fl aps will stop at the upper position when the airfl ow rate is changed to low during theup and down swing setting.Note on 3-D airflow• Using 3-D airfl ow circulates cold air, which tends to collected at the bottom of the room,and hot air, which tends to collect near the ceiling, throughout the room, preventing areasof cold and hot developing.COOL / DRYFAN HEATMovable range of the fl aps