Display5Names of PartsIndoor UnitAppearance of the indoor unit may differ.•Air inletUpper frontpanelAir outletLouvres (vertical blades)The louvres are inside of the air outlet.• Page 13INTELLIGENT EYEsensorIt detects the movements•of people and automaticallyswitches between normaloperation and energysaving operation. Page 15Flaps(horizontalblades)Page 13INTELLIGENT EYE lamp(green) Page 16Signal receiver and Indoorunit ON/OFF switchSignal receiverIt receives signals from the remote•controller.When the unit receives a signal, you will•hear a beep sound.Case Sound typeOperation start beep-beepSetting changed beepOperation stop long beepIndoor unit ON/OFF switchPress this switch once to start operation.•Press once again to stop it.For the operation mode setting, refer to the following•table.Mode Temperature setting Airfl ow rateAUTO 25°C AUTOThis switch can be used when the remote controller is•missing.TIMER lampWhen operation by timer has been set, the multi-monitor lamp•periodically changes to orange. After lighting orange for about5 seconds, it returns to the colour of the operation mode.The multi-monitor lamp will turn orange on and off in cyclicmanner while the air conditioner is not in operation.TIMER lamp colourTIMER lamp colour : For COOLOrangeBlue3 min.5 sec. 5 sec.2 sec. 2 sec. 2 sec. Green OrangeDRY :COOL : Blue OrangeHEAT : Red OrangeFAN : White OrangeStop : Off OrangeIndoor temperaturesensorIt detects the air•temperature around theunit.Multi-monitor lamp andTIMER lampMulti-monitor lampThe lamp colour changes according to•the operation.Operation Multi-monitor lampAUTO Red/BlueDRY GreenCOOL BlueHEAT RedFAN WhiteTIMER OrangeLower front panelIt is located on the back of the•upper front panel during operation.01_EN_3P357704-1.indd 501_EN_3P357704-1.indd 5 12/17/2013 3:21:55 PM12/17/2013 3:21:55 PM