Daikin FTXJ20MV1BW Installation Manual

Also see for FTXJ20MV1BS: Operation manual

Contents

Daikin FTXJ20MV1BW Installation Manual Manual pdf 6 page image

4 ■ EnglishInstallation Tips1. Removing and installing the upper front panel2. Removing and installing the front grille• Removal method1) Remove the upper front panel and air filters.2) Remove the service lid. (Refer to the opening method on page 3.)3) Disconnect the wire harnesses from the wire clamp, and remove the wireharnesses from the connectors.4) Push the lower front panel up until it stops.5) Dismount the flap (large).6) Open the 2 screw covers, and remove 4 screws from the front grille.(The screw covers are not factory-mounted.)Ŷ Removal method1) Open the upper front panel.2) Slide the front panel locks on the back of the front panel upward to release the locks (left and right sides).3) Remove the panel shafts on both sides from the shaft holes, and dismount the upper front panel.Ŷ Installation method1) Slide the front panel locks on the back of the front panel upward to release thelocks (left and right sides).2) Insert the panel shafts on both sides of the upper front panel into the shaft holes.3) Slide the front panel locks on each side downward to lock them.4) Close the upper panel.5) Do NOT push on the front panel to close it.6) Turn ON the unit by remocon. Wait till the panels are completely open. Then, turnOFF the unit by remocon again.7) Once the front panels close completely, gently push the upper front panel to hookit into position.3-1) SlideShaft hole3-2) Pull2) SlideThe upper front panel does notopen any more than as shown inthe figure. Do not force it openany further than that.“click”“click”ON/OFF“click”4)5)6)7)Back of the upper front panelBack of the upper front panelFront panel lockFront panel shaftWire clampConnectorsWire harnessesFlap (large) Flap (small)4 screws• Opening methodScrew coverUse a long flat plate such as aruler and wrap it in a cloth soas not to damage the product.Downward