Daikin FTXP20L2V1B Operation Manual

Also see for FTXP20L2V1B: Installer's reference guide Installation manual

Contents

Daikin FTXP20L2V1B Operation Manual Manual pdf 6 page image

4 OperationOperation manual6FTXP20~35L2V1BR32 split series3P511999-1 – 2017.114.3.3 Airflow directionWhen. Adjust the airflow direction as desired.What. The system directs the airflow differently, depending on theuser selection (swinging or fixed position). It does so by moving thevertical blades.Setting Airflow directionVertical auto swing Moves up and down.[—] Stays in a fixed position.CAUTION▪ ALWAYS use a user interface to adjust the angles ofthe flap. When the flap is swinging and you move itforcibly by hand, the mechanism will break.▪ Be careful when adjusting the louvers. Inside the airoutlet, a fan is rotating at high speed.Note: The movable range of the flap varies according to theoperation mode. The flap will stop at the upper position when theairflow rate is changed to low during the up and down swing setting.abca Flap range in cooling or drying operationb Flap range in heating operationc Flap range in fan only operationTo adjust the airflow direction1 To use auto swing, press .Result: will appear on the LCD.Result: The flap (horizontal blade) will begin to swing.2 To use fixed position, press when the flap reaches thedesired position.Result: disappears from the LCD.To adjust the louvers (vertical blades)1 Hold 1 or both knobs and move the louvers.aaa KnobsINFORMATIONWhen the unit is installed in a corner of a room, thedirection of the louvers should be facing away from thewall. Efficiency will drop if a wall blocks the air.4.3.4 Comfort airflow operationThis operation can be used in Heating or Cooling operation mode.It will provide a comfortable wind that will NOT come in direct contactwith people.To start/stop Comfort airflow operationINFORMATIONPowerful and Comfort airflow operation CANNOT be usedat the same time. The last selected function takes priority.If the upper or lower direction is selected, Comfort airflowoperation will be cancelled.1 Press to start.Result: The flap position will change, is displayed on theLCD, and the airflow rate is set to automatic.Mode Position of flap…Cooling/Drying UpHeating DownNote: Comfort airflow operation is NOT available in Fan only mode.2 Press to stop.Result: The flap will return to the position from before the Comfortairflow mode; disappears from the LCD.4.3.5 Powerful operationThis operation quickly maximizes the cooling/heating effect in anyoperation mode. You can get the maximum capacity.To start/stop Powerful operation1 Press to start.Result: is displayed on the LCD. Powerful operation runsfor 20 minutes; after that, operation returns to the previously setmode.Mode Airflow rateCooling/Heating/Automatic ▪ To maximize the cooling/heating effect, the capacity ofoutdoor unit is increased.▪ The airflow rate is fixed to themaximum setting.The temperature and airflowsettings CANNOT be changed.Drying ▪ The temperature setting islowered by 2.5°C.▪ The airflow rate is slightlyincreased.Fan only The airflow rate is fixed to themaximum setting.2 Press to stop.Result: disappears from the LCD.INFORMATIONPowerful operation CANNOT be used together with Econoand Comfort airflow operation. The last selected functiontakes priority.Powerful operation will NOT increase the capacity of theunit if it already operates at maximum capacity.