■English 21■ To use ON TIMER operation• Check that the clock is correct. If not, set the clock to thepresent time. (page 9.)1. Press “ON TIMER button”.is displayed.blinks.2. Press “TIMER Setting button” until the timesetting reaches the point you like.• Every pressing of either button increases or decreasesthe time setting by 10 minutes. Holding down eitherbutton changes the setting rapidly.3. Press “ON TIMER button” again.• The TIMER lamp lights up.■ To cancel ON TIMER operation4. Press “CANCEL button”.• The TIMER lamp goes off.■ To combine ON TIMER and OFF TIMER• A sample setting for combining the two timers is shown below.ATTENTION■ In the following cases, set the timer again.• After a breaker has turned OFF.• After a power failure.• After replacing batteries in the remote controller.FTEMPON/OFFPOWERFULHOME LEAVEMODE FAN SWINGQUIET SENSORFTIMERON CANCELOFF21, 34ONOFF