Daikin FTXS15HVJU Operation Manual

Also see for FTXS24HVJU: Service manual Service manual Engineeiring data

Contents

Daikin FTXS15HVJU Operation Manual Manual pdf 9 page image

8Preparation before Operation To set the batteriesSlide the front cover to take it off.1.Set 2 dry batteries AAA.LR03 (alkaline).2.Set the front cover as before.3. To fi x the remote controller holder on the wallChoose a place from where the signals reach1. the unit.Fix the holder to a wall, a pillar, etc. with the2. screws supplied with the holder.Place the remote controller in the remote3. controller holder.Celsius/Fahrenheit display switchThe Celsius or Fahrenheit display is selectable with the following buttons.•Press and buttons simultaneouslyfor 5 seconds.The temperature will be displayed in Fahrenheit if it is presently displayed in Celsius, and•vice versa.231Position andcorrectly!+–Remote controllerholderSet. Pull.ATTENTIONAbout batteriesWhen replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.•When the system is not used for a long time, take the batteries out.•The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs•within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).The attached batteries are provided for the initial use of the system.•The usable period of the batteries may be short depending on the manufactured date of the air conditioner.About remote controllerNever expose the remote controller to direct sunlight.•Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.•Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the shop•if that is the case.If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.•Celsius/Fahrenheit display change function of remote controllerThe set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.•Example: A set temperature of 64°F (equivalent to 18.5°C) will be converted into 19°C.•When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of theoriginal set temperature (64°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display change function.•