5■ Outdoor Unit■ Indoor Unit1. Air filter2. Titanium Apatite PhotocatalyticAir-Purifying Filter:• These filters are attached to the inside ofthe air filters.3. Air inlet4. Front panel5. Panel tab6. Room temperature sensor:• It senses the air temperature around theunit.7. INTELLIGENT EYE sensor: (page 14.)8. Display9. Air outlet10. Horizontal blades (flaps): (page 12.)11. Vertical blades (louvers):• The louvers are inside of the air outlet.(page 12.)12. Indoor Unit ON/OFF switch: (page 10.)• Push this switch once to start operation.Push once again to stop it.• The operation mode refers to the followingtable.• This switch is useful when the remotecontroller is missing.13. Operation lamp (green)14. TIMER lamp (yellow): (page 20.)15. INTELLIGENT EYE lamp (green): (page 14.)16. Signal receiver:• It receives signals from the remote controller.• When the unit receives a signal, you willhear a short beep.• Operation start ........ beep-beep• Settings changed ..... beep• Operation stop.......... beeeeep■ Outdoor Unit17. Air inlet: (Back and side)18. Refrigerant piping and inter-unit cable19. Drain hose20. Earth terminal:• It is inside of this cover.21. Air outlet20/25/35/42 class 50 class18192021171819202117Model Mode TemperaturesettingAirflowrateCOOLINGONLY COOL 22°C AUTOHEATPUMP AUTO 25°C AUTO01_EN_3P207037-1.fm Page 5 Monday, September 10, 2007 5:16 PM