5■ Outdoor Unit■ Indoor Unit1. Air filter2. Titanium Apatite PhotocatalyticAir-Purifying Filter:• These filters are attached to the inside of the airfilters.3. Air inlet4. Front panel5. Panel tab6. Room temperature sensor:• It senses the air temperature around the unit.7. Display8. Air outlet9. Flaps (horizontal blades): (page 12.)10. Louvres (vertical blades):• The louvers are inside of the air outlet.(page 13.)11. Indoor Unit ON/OFF switch: (page 10.)• Push this switch once to start operation.Push once again to stop it.• The operation mode refers to the followingtable.• This switch is useful when the remote controlleris missing.12. Operation lamp (green)13. TIMER lamp (yellow): (page 15.)14. Signal receiver:• It receives signals from the remote controller.• When the unit receives a signal, you will hear ashort beep.• Operation start .............beep-beep• Settings changed..........beep• Operation stop ..............beeeeep■ Outdoor Unit15. Air inlet: (Back and side)16. Air outlet17. Refrigerant piping and inter-unit cable18. Drain hose19. Earth terminal:• It is inside of this cover.20. Outside air temperature sensor:• It senses the ambient temperature around theunit.Appearance of the outdoor unit may differ from some models.172018191615Mode Temperaturesetting Air flow rateAUTO 25°C AUTO