3ŶEnglishAccessoriesA Mounting plate 1 B Titanium apatite photocatalyticair-purifying filter 2 C Drain hose 1D Insulation tape 2 E Wireless remote controller 1 F Remote controller holder 1GFixing screw for remotecontroller holder 1/8” × 13/16”(M3 × 20mm)2 H Dry battery AAA. LR03(alkaline) 2 J Operation manual 1K Installation manual 1Choosing an Installation Site• Before choosing the installation site, obtain user approval.1� Indoor unitThe indoor unit should be positioned in a place where:1) the restrictions on installation requirements specified in “Indoor Unit Installation Drawings” on page 4 are met,2) both the air inlet and air outlet are unobstructed,3) the unit is not exposed to direct sunlight,4) the unit is away from the source of heat or steam,5) there is no source of machine oil vapour (this may shorten the indoor unit service life),6) cool/warm air is circulated throughout the room,7) the unit is away from electronic ignition type fluorescent lamps (inverter or rapid start type) as they may affect the remotecontroller range,8) the unit is at least 3.3ft (1m) away from any television or radio set (the unit may cause interference with the picture orsound),9) no laundry equipment is nearby.2� Wireless remote controllerTurn on all the fluorescent lamps in the room, if any, and find a location where remote controller signals are properlyreceived by the indoor unit (within 23ft (7m)).