Outdoor Unit Si181296_A12 Removal Procedure1.3 Outdoor Fans / Fan MotorsWarning Be sure to wait for 10 minutes or more after turning off all power supplies beforedisassembling work.Step Procedure Points1 Remove the nuts andremove the outdoorfans. Nut size : M8 When reassembling, alignthe mark of the outdoorfan with the D-cut section ofthe motor shaft.2 Cut the clamp. Pull out the connector whilesupporting the fan motor andpushing the engaging hook,without pulling its lead wires. When reassembling, put thefan motor lead wire throughthe back of the fan motor (soas not to be entangled withthe outdoor fan). Be sure to remove the lowerscrews first. If the upperscrews are removed first, thefan motor, the center ofgravity of which is toward thefront, may tilt down or fall,getting you injured.3 Remove the 4 screwsand remove the fanmotor.Outdoor fanNut with a washer (R12974)13 mm(0.51 inch)(R18965)Earth / ground wireClampD-cut(R18515)FanmotorMount the fan motor with its mark "z"positioned toward the bottom.(R3249)Lead wire Outdoor fan