Daitsu ADD12 Instruction Manual

Contents

Daitsu ADD12 Instruction Manual Manual pdf 7 page image

- 41 -INGLESOperationDrainage steps2. Discard the water3. Place back the drainage tankNotation for drainagel When place back the drainage tank, press thetank firmly into place with both hands. If thetank is not positioned properly, the “Tank Full”sensor will be activated, and the dehumidifierwill not operate.Check to make sure the guards are firmly atta-ched to the tank. If they are not, the drainagetank will be harder to remove.l If the drainage tank is removed while the unitis in operation, or immediately after operationhas stopped, water which is still in the coolingunit may drip out on the base plate. Wait atleast 30 minutes before removing the drainagetank. (If water has dripped, wipe it up.)Continuous drainage of waterThe unit has a continuous drainage port. Using a commercial hose (with an inner diameter of 15mm),the water in the drainage tank can be continuously drained out of the continuous port of the unit.When setting up the equipment for continuous drainage, always stop operation first and unplug thepower supply plug.Operation1. Disconnect the drainage tank and open the continuous drainage port.Use nippers or a similar tool to cut away the continuous drainageport in the side of the main unit.2. Push the hose into the continuous drainage port.Pass a commercial hose (with an inner diameter of 15mm) throughthe continuous drainage port, and press it firmly into the drainageport in the main unit, make sure water does not leak. The levelheight of drain piping should always be not higher than the one ofthe drainage port, also drain piping should always be not pluggedup, so the condensed water can be drained out successfully.3. Return the drainage tank to its original position.Check the hose periodically to make sure it is still connected and hasnot been obstructed.l Draining the waterDrain waterfrom this pointGuard