Dake SE-5X8 Instructional Manual

Contents

Dake SE-5X8 Instructional Manual Manual pdf 17 page image

Dake Corporation724 Robbins RoadGrand Haven, MI 49417www.dakecorp.com16 REV032019DANGER - WARNINGTO GET OPTIMUM PERFORMANCE FROM YOUR BLADE, CARRY OUT THE BREAK-INPROCEDURE. ALWAYS BREAK-IN THE BLADE USING THE BLADE MANUFACTURESBREAK-IN RECOMMENDATIONS. IF UNAVAILABLE THESE STEPS WILL PROVIDEGENERIC BREAK-IN PROCEDURES.Start out making three cuts, putting only a light pressure on the workpiece.Light pressure: as an example, consider an operation to cut a solid steel bar (e.g. C40, D .2”dia). This should be cut in about 4 minutes. Once the blade has been broken-in the sameworkpiece can easily be cut in about 2 minutes.LUBRICATION / COOLANTThe machine does not need lubricating / coolant.CLEANINGDANGER – WARNING• Wear suitable personal protective equipment (e.g. safety glasses, etc.).• Avoid using compressed air.• Keep saw and surrounding areas clean from debris.