Dakota Alert DCR-2500 User Manual

Also see for DCR-2500: User guide

Contents

Dakota Alert DCR-2500 User Manual Manual pdf 4 page image

Freephone New Zealand: 0508 242 333Phone (64) 6 751 2969Fax (64) 751 2717PO Box 730, New Plymouth 4342NEW ZEALANDEXIT DELAY:The receiver can be programmed to have a 5 minute exit delay where it will not receive a signal fromselected transmitters.1. The jumper “J3” (Figure 1-6) can be used to determine which zone(s) you would like to use with the exitdelay. To use the exit delay set the jumper to cover both pins for the desired zone(s).2. To start the exit delay press the “B” button (Figure 1-9) for 0.5 seconds and release. The green led will flashfor 5 minutes and during this time no signals will be received from the selected zones.Note: Whenever a change is made to the jumpers or the dip switches, the receiver must be turned“OFF” and then back “ON” to operate properly.Frequency: 433.92 MHzOperating voltage: 12VDC12 volt DC output current: 400 mA maximumRelay rating: 24VDC at 3 AmpTECHNICAL SUPPORT:If you encounter any difficulty in the operation of this product after reading the manual, please contact us.We will be happy to answer your questions and help you in any way we can.WARRANTY:Dakota Alert warrants this product to be free of defects in material and workmanship for a period of oneyear from the date of purchase. This warranty does not cover damage resulting from accident, abuse, act ofGod or improper operation. If this product does become defective, simply return it to Target Technology Ltd.Please include a note describing the troubles along with your name and return address as well as the originalsales receipt. If the product is covered under warranty it will be repaired or replaced at no charge. If it is notcovered by warranty, you will be notified of any charges before work is done.Freephone Australia: 1300 588 195Fax (64) 751 2717PO Box 8181, BargaraQueensland 4670AUSTRALIA

/ 4

Related manuals for Dakota Alert DCR-2500