Daktronics BA-515 Display Manual

Also see for BA-1018: DISPLAY MANUAL Installation, Maintenance, and Specifications Manual

Contents

Daktronics BA-515 Display Manual Manual pdf 44 page image

Mounting Method 1Reference Drawings:Display Mounting .....................................................Drawing A-44412Ad Panel Mounting ..................................................Drawing A-52187Drawing A-44412 shows the hardware used for mounting the scoreboard to thebeams. Mounting hardware includes inner and outer mounting clamps, clip angles,1/2-13 x 15" threaded rods, 3/8-16 x 2" bolts, hex nuts and split lockwashers, and 1/2"square nuts, hex nuts, and split lockwashers. Each section of the scoreboard attachesat the top and the bottom to all the beams. The drawing also shows top and sideviews of the scoreboard secured to the beams.Note: The threaded rods do not pass through the flanges of the beams, but insteadrun along both sides of each beam.Refer to the installation specifications drawing for your scoreboard model (listed inSection 6.2) to determine the center-to-center distance of the poles for each model.Review the illustration of the mounting hardware in Drawing A-44412, or refer toFigure 4, and then use the following procedure for each section.1. Using 3/8" bolts, loosely attach the inner and outer mounting clamps to therear flanges of the scoreboard horizontal frame members. Measure the beamspacing and position the clamps to fit on either side of the beams.Figure 4: Clamp Mounting Method, Side View2. Insert a 1/2" square nut into each mounting clamp. Screw a threaded rod intoeach of the nuts from the rear.3. Position the scoreboard at the front of the beams with the threaded rodsextending from the rear of the clamps, straddling the beams. Raise thescoreboard section to the desired height.4. Slide clamping angles over the ends of the rods and loosely install thewashers and nuts.Mechanical Installation 6-7