RC-100 Base Station 7Section 3: RC-100 Base StationThe RC-100 wireless Base Station is used to communicate with all RC-100 wireless handheldcontrollers on the same channel setting. The RC-100 wireless Base Station also is used to updateconnected displays based with information entered on the wireless handheld controller.The wireless Base Station includes two switches that must be set to specify the function number andchannel of operation. Refer to Section 3.1 and Section 3.2, respectively. In addition, the Base Stationincludes a server/client jumper that must be set to “Client Mode” in some scenarios that featuremultiple displays. Refer to Section 3.4 for more information.3.1 Function SettingThe desired RC-100 system function must be configured in the wireless Base Station. A list ofpossible current functions is shown below, along with the corresponding Function Setting.FunctionSettingFunction(Base Station Server Mode*)Function(Base Station Client Mode*)0Default Function(last power up function) All Display Groups1 CAN Handheld (Judges') Console Display Group 12 GEN I All Sport Scoreboard Controller Display Group 23 DataTime/DataMaster Display Control Display Group 34 Reserved Display Group 45 GEN II All Sport Scoreboard Controller Display Group 26 Reserved7 Reserved8 Reserved9 ReservedA ReservedB ReservedC ReservedD ReservedE ReservedF Reset Memory/Test** Reset Memory/Test*** The function of the Base Station depends on whether it is in Server or Client mode. For aserver Base Station, the Function switch sets up the desired application. For a client BaseStation, the Function switch sets up the display group to which this display belongs.**Function Setting “F” is a special setting which resets all saved memory parameters back todefaults. This can be used for situations such as when a password needs to be reset. To usethis function, cycle power to the wireless Base Station with the switch in this position andleave on for 10 seconds. Remove power, change to the desired function and continue. Allsaved memory parameters will be set back to default.