Dal Zotto MARTA IDRO 2.0 User Manual

Contents

Dal Zotto MARTA IDRO 2.0 User Manual Manual pdf 47 page image

JOLE IDRO 2.0 MARTA IDRO 2.0ENGLISHADDITIONAL THERMOSTATN.B. : Installation must be performed by an authorised technician.There is a possibility to thermostat a room adjacent to the room where the stove is positioned: just connect a thermostat following the proceduredescribed in the next step (it is recommended to position the optional mechanical thermostat at a height of 1.50 m from the floor) . Stovefunctioning with the external thermostat connected in the TA clamp can be different on the basis of the activation or disabling of the STBYfunction.The TA clamp leaves the factory jumpered, therefore it is always with closed contact (on request).ADDITIONAL THERMOSTAT FUNCTIONING WITH STBY ACTIVEWhen the STBY function is activated, the LED flashes. When the contact or external thermostat is satisfied (open contact / temperaturereached), the stove will switch off. As soon as the contact or external thermostat switches to the "not satisfied" status (closed contact/temperature to be reached) it will re-ignite.N.B.: stove operation depends on the temperature of the water inside the stove and relative factory setting restrictions. If the stoveis in H OFF (water temperature reached), any additional contact or thermostat request will be ignored.ADDITIONAL THERMOSTAT FUNCTIONING WITH STBY DEACTIVATEDWhen the STBY function is disabled, the LED is fixed.When the contact or external thermostat is satisfied (open contact / temperature reached), the stove will go to minimum. As soon as thecontact or external thermostat switches to the "not satisfied" status (closed contact / temperature to be reached) the stove will start to workagain at the pre-set power.N.B.: stove operation depends on the temperature of the water inside the stove and relative factory setting restrictions. If the stoveis in H OFF (water temperature reached), any additional contact or thermostat request will be ignored.ADDITIONAL THERMOSTAT INSTALLATION� Switch the appliance off using the master switch positioned on the rear of the stove.� Remove the plug from the socket.� Refer to the electrical layout to connect the two thermostat cables to the relative clamps positioned on the rear of the machine, one isred and the other black (TA clamp). Every model can have a different position of the relative clamps in the rear of the machine. Theimage is given as an example.J REFER TO THE ''SETTINGS'' CHAPTER TO ACTIVATE STAND BY47