Dalsa Rad-icon 1520 User Manual
                                     | |
Contents
| 
Rad-icon 1520 GigE User Manual 19Teledyne DALSAConnecting1. After the install is complete, plug in the detectors communication cable.2. Power up the detector.3. After powering up the detector, the application automatically detects the detector.This may take 30 to 60 seconds. Wait until the detector connected indicator in the taskbar (shown below) has confirmed that a connection has been established (the red crossover the camera icon disappears).Checking detector status and information in Gigabit EthernetAfter the detector connection has been established, the status of the connection can bedisplayed by right clicking on the camera icon in the task bar and selecting “SHOWStatus Dialog Box.”When you add or remove a detector from the network, it is automatically detected by theGigE server. A manual network scan can also be launched from this menu by selecting“Scan Network.” This action will refresh the information of the device connected to thenetwork. The “About Sapera GigE Server” option will display the version of the installedGigE driver.Selecting the “SHOW Status Dialog Box” will open the device status window, whichdisplays the basic information of the detector- Serial Number- Model Name- MAC Address- Packet size, which should be 9000- Firmware version (build number)- IP addresses ofo Detectoro Network Interface Card on host system to which the detector isconnectedThe default assigned detector IP address can be modified using the Teledyne DALSANetwork Configuration Tool, which is part of the installation package. |
Related manuals for Dalsa Rad-icon 1520
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine