Danby DBD5L Owner's Manual
                                          | |
OPERATING THE BEVERAGE DISPENSERSwitching On The PowerCAUTION: Switch on the beverage dispenser only when the mini keg or thecontainer is properly connected (See “Connecting the Beverage Disenser ” onpages 10-14).Make sure to clean up any liquids that have spilled in and around thebeverage dispenser.1. Make sure the beverage dispenser is properly connected to a mini keg orto the container.2. Close the lid.3. Insert the Power cable into a properly grounded 3 prong outlet(See “Important Safety Information ” on page 4).4. Press the ON /OFF switch located on the bottom panel in the back of theunit (SeeFigure 17 ).5. Make sure the air pressure switch is in its proper setting. If necessary, referto the AIR PRESSURE sections in “Connecting the Beverage Dispenser ” onpages 10-14.+ = WARMER= COOLER15Cooling the Beverage DispenserIt takes approximately 15 hours for the beverage dispenser to chill a standard5 liter mini keg from normal room temperature of 72°F (22°C) to a desireddrinking temperature of 41°F (5°C).1. To cool the beverage dispenser, use the temperature regulator located inback of the unit and next to the power switch.2. To make the beverage dispenser warmer, turn the temperature adjustor tothe + direction. To make the dispenser cooler, turn the temperature adjustor tothe - direction (SeeFigure 18 ).Adjusting the internal temperature with the temperature adjustor will have agradual effect on the temperature of the beverage. It should take at least 2-3hours for the beverage dispenser temperature to reach the desiredtemperature when a change is being made.The internal temperature of the dispenser is displayed on the front of the unit.NOTE: The temperature displayed on the front of the dispenser is measuredby the temperature on the outside of the keg or container. Consequently, thedisplayed temperature may sometimes vary from the actual temperature of thebeverage. This depends on the length of time and temperature at which thekeg and container were chilled.Figure 17Figure 18= OFF= ONTemperature Conversion ChartcF1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 1834 36 37 39 41 43 44 46 48 50 52 54 55 57 59 61 63 64+ |
Related manuals for Danby DBD5L
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine