Danby DWM99W Owner's Manual

Danby DWM99W Owner's Manual Manual pdf 10 page image

9• Connect the opposite end of the fill hoses to theirrespective HOT & COLD water supply lines. Fig. IIMPORTANT: Make sure the HOT water line isconnected to the HOT (upper) water valve and theCOLD water line is connected to the COLD(lower) water valve. Fig. I• Slowly open both water supply lines and check forany sign of leaks at all connection points.• If leaks occur, immediately close the water supplylines and effect the necessary repairs and/orreplacement of any/all defective connections.• If you are unable to effect suitable repairsyourself, call our toll free CUSTOMER HELP LINEat "1 800 26 DANBY and ask for assistance.STEP 3Connect Drain Hose to DrainReceptaclePortable Installation: Hang the drain pipe over theedge of the wash tub and/or kitchen sink. Makesure the hose cannot be accidentally displacedwhen the drain water is being discharged.Permanent Installation: Insert the end of the drainhose directly into the drain stem pipe and /or hangover the edge of the wash tub.NOTE: The highestpoint of the drainhose must bepositioned between26" ~ 46" abovefloor level, otherwisethe pumping out(efficiency) of thewater may beaffected. Fig. JSTEP 4Levelling the Washing Machine.To prevent vibration and unnecessary movementduring wash and spin operation, the washer mustbe installed on a firm and level surface, This isaccomplished by using the level adjustment knoblocated on the lower right side of the cabinet. Tochange the height of the adjustment leg, unscrewthe level adjustment knob, set the machine leveland re-tighten when the machine is stable. Fig. MThe inclination angle of the washer shall not bemore than two (2º) degrees.Place the washer atleast 5cm (2") away from the wall.Portable Installations: For portable applications,the washing machine comes equipped with four (4)"north/south" casters that can easily be installed toassist in the movement of the machine too and fromthe sink. Lay the unit on its back.Install the casters into the bottom of the base asdepicted. Fig. NReturn the machine to the upright position.When the machine is positioned for operation, setthe height of the adjustment leg slightly higher thanthe front caster to prevent movement of themachine during wash and spin operation.NOTE: Not all movement will be totally eliminated,this is normal.TapConnectorConnectingNutIWaterInlet HoseJCorrectLevelAdjustment KnobMLoosen TightenIncorrectNAdjustable FootCastorCastorFixed FootFixed FootCastorCastorFixed foot