Danby Designer DUF5012WDD Owner's Use And Care Manual

Also see for Designer DUF448WDD: Owner's use and care guide Owner's guide

Contents

Danby Designer DUF5012WDD Owner's Use And Care Manual Manual pdf 5 page image

5Electrical RequirementsBefore you move your freezer into its final location, it is importantto make sure you have the proper electrical connection.Recommended grounding methodA 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, groundedelectrical supply is required. It is recommended that a separatecircuit serving only your freezer be provided. Use an outlet thatcannot be turned off by a switch. Do not use an extension cord.NOTE: Before performing any type of installation, cleaning, orremoving a light bulb, turn the Temperature Control to the OFFposition as shown and then disconnect the freezer from theelectrical source.Freezer DoorTOOLS NEEDED: ⁵⁄₈" hex-head socket wrench, ¹⁄₄" hex-headsocket wrench, ¹⁄₂" hex-head socket wrench, ³⁄₈" hex-head socketwrench, #2 Phillips screwdriver, flat-blade screwdriver, ⁵⁄₁₆" open-end wrench, flat 2" putty knife.IMPORTANT:■ All graphics referenced in the following instructions areincluded later in this section after “Final Steps.” The graphicsshown are for a right-hand swing door (hinges factory installedon the right).■ If you only want to remove and replace the door, see the“Remove Door and Hinges” and “Replace Door and Hinges.”■ Before you begin, turn the control OFF, and remove food andadjustable door or utility bins from door.Install and Remove HandleNOTE: If reversing the door swing, move the handle from one sideof the door to the other side.To install handle:1. Place the handle on the door as shown. See Handle graphic.2. Using a flat-blade screwdriver, attach the handle to the doorwith the four handle screws (provided).3. Place the trim pieces on the upper and lower handle ends asshown.4. Apply firm pressure with your hand on the face of the trim.Slide the top trim down and the bottom trim up toward thehandle.To remove handle:1. Remove the top and bottom trim.2. Using a flat-blade screwdriver remove the four handle screwsand lift off the handle.Remove Door and Hinges⁵⁄₁₆" Hex-Head Hinge Screw1. Unplug freezer or disconnect power.2. Open freezer door and remove base grille from the bottomfront of the freezer. See Base Grille graphic 1A.3. Close the freezer door and keep it closed until you are readyto lift it free from the cabinet.NOTE: Provide additional support for the door while thehinges are being moved. Do not depend on the door magnetsto hold the door in place while you are working.4. Remove the parts for the top hinge as shown in Top Hingegraphic 1B.5. Lift the freezer door free from the lower hinge and cabinet andset aside.6. Remove three hex head hinge screws and bottom hingeassembly. See Bottom Hinge graphic 1C.Electrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.WARNING