Danby Silhouette Select DWRH301SSST Owner's Manual
               | |
ASeparate the extension flue bypulling it upward.17-1/2”16-1/2”Remove the plasticfound on the flues.FIG. 3Remove filters andstyrofoam piecesfrom inside therangehood.1.Push in tab2.Pull downward1) MARK REFERENCE POINTS ON WALLThe bottom of the range hood must sit between 26”(min) and 36” (max) above the stove top. The screwholes must be situated 9 1/2” above the point wherethe bottom of the range hood will hang. The screwholes for mounting the range hood must be 7 7/8”apart. Refer to Fig. 2 and mark these reference pointson the wall before installing the range hood. Then, drill2 screws into the wall but not tightly: you must leavesome of the screw (roughly half an inch) out of the walluntil after the range hood is mounted.2) MOUNTING THE RANGE HOOD ON THEWALLBefore mounting the range hood on the wall please take outthe filters and remove any plastic or styrofoam found insidethe range hood (see Fig. 3 and Fig. 4.) Leave the fi lters outuntil Step 3 is finished.FIG. 4 - PEEL OFF PLASTIC FROM THE FLUESFIG. 226” min34” maxCEILING7-7/8”9-1/2”F & HF & HINSTALLATION INSTRUCTIONS4 |
Related manuals for Danby Silhouette Select DWRH301SSST
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine