Danelec DM700 ECDIS User Manual
Also see for DM700 ECDIS: Installation manual
                              | |
Contents
| 
User manual for DM700 ECDIS hardwareCopyright Danelec Marine A/SMAN11804-10 Page 27/308.2 Diagnose errors/malfunctionsThis section describes common solutions for some errors and malfunctions in the DM700 ECDIS.No image on the display1. Verify that the DM700 ECDIS DPU is turned on. (CPU status LED must be GREEN)2. Change monitor mode to DAY by pressing F6 on the keyboard up to three times.3. Reset monitor settings at each monitor mode by pressing F8 in each monitor mode.4. Check the DVI cable is connected to the DVI port of the DM700 ECDIS DPU, and the DVIport of the monitor.5. Check the RS232 cable is connected to COM1 port of the DM700 ECDIS DPU, and theRS232 port of the monitor.6. Verify power is connected to the monitor, and turned ON.7. Repeat step 2 and 38. Turn off the DM700 ECDIS computer by pressing the “POWER” button on the monitorHMI for 10 seconds. Release the button, and then briefly press the button again.9. Contact a Danelec service partner for further assistance.USB Disk is not recognized1. Verify the USB Stick is correctly plugged into the USB port 1 on the front of the DM700DPU.2. Check the USB disk file system. Supported formats are: FAT, FAT32 or NTFS.3. Contact a Danelec service partner for further assistance.No data is received from any of the remote ECDIS nodes1. Verify an Ethernet cable is connected to Ethernet port ‘LAN1’.2. Verify the remote ECDIS node is turned on.3. Contact a Danelec service partner for further assistance.No sound from the buzzer1. Verify the monitor is connected correctly to the DM700 ECDIS DPU by adjusting thebacklight of the monitor. The backlight should change.2. Verify the monitor HMI is correctly connected to the monitor by pressing the POWERbutton briefly. You should see a standby dialog popping up.3. If you do not see a standby dialog, verify the cable from the monitor HMI is connected tothe monitor.4. Adjust the buzzer in “Shortcuts”-menu (Main MenuShortcuts or Press F1) by pressingthe + and – buttons, and also verify sound is not turned off.5. Contact a Danelec service partner for further assistance.The backlight of the monitor cannot be controlled1. Check the RS232 cable is connected to COM1 port of the DM/00 ECDIS DPU, and theRS232 port of the monitor.2. Contact a Danelec service partner for further assistance.The ECDIS will not start1. Verify AC power is connected to the monitor. The AC LED will be lit.2. Verify DC is connected from the monitor to the DM700 ECDIS DPU. |
Related manuals for Danelec DM700 ECDIS
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine