Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual

Also see for ADAP-KOOL AKD 102: Operating instructions

Contents

Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual Manual pdf 30 page image

3.4.3 Installation on PedestalThis section describes the installation of a pedestal unit available for thefrequency converters frames D1 and D2. This is a 200 mm high pedestalthat allows these frames to be floor mounted. The front of the pedestalhas openings for input air to the power components.The frequency converter gland plate must be installed to provide ade-quate cooling air to the control components of the frequency convertervia the door fan and to maintain the IP21/NEMA 1 or IP54/NEMA 12 de-grees of enclosure protections.Illustration 3.17: Drive on pedestalThere is one pedestal that fits both frames D1 and D2. Its ordering number is 176F1827. The pedestal is standard for E1 frame.Illustration 3.18: Mounting of drive to pedestal.3.4.4 Installation of Input Plate OptionsThis section is for the field installation of input option kits available for frequency converters in all D and E frames.Do not attempt to remove RFI filters from input plates. Damage may occur to RFI filters if they are removed from the input plate.NB!Where RFI filters are available, there are two different type of RFI filters depending on the input plate combination and the RFI filtersinterchangeable. Field installable kits in certain cases are the same for all voltages.3 Mechanical Installation ADAP-KOOL® Drive AKD 102 High Power30 MG.11.O1.02 - ADAP-KOOL® is a registered Danfoss trademark3