Danfoss CLX Home Installation Manual

Contents

Danfoss CLX Home Installation Manual Manual pdf 3 page image

1. Introduction1.1. Safety InstructionsThe reader must be familiar with the rules and regulations for electrical equipment and connec-tion to the mains power network. Pay particular attention to general safety regulations forworking with electrical systems.Observe the safety instructions below to prevent injury to persons and damage to connectedequipment.Contact with electrically conductive parts after disconnection from the mains supply can be dan-gerous. Do not connect the equipment to the mains supply before installation.Equipment must be installed only in protected/dry environments.Do not use metallic/pointed/sharp instruments to access the enclosure.Prevent cables and terminals from being exposed.The power plug must be accessible at all times.Qualified personnel only must perform service.Equipment must only be operated at the rated supply voltages. A suitable powersupply unit is included in the scope of delivery.Note:Observe the manufacturer's instructions regarding the handling of power supply units (espe-cially switching units).Observe the manufacturer's instructions regarding the handling of inverters.1.2. IntroductionThis document describes how to configure the CLX Home product for use with a Danfoss solarinverter to enable monitoring of up to 3 DLX, ULX, TLX, TLX+, TLX Pro, TLX Pro+, FLX or FLXPro *) inverters from a Smartphone, tablet or PC-based browser.*) TLX Pro, TLX Pro+ and FLX Pro variants only when the inverters are connected via RS-485 and not us-ing the master/follower concept.To install and configure the CLX Home box:• Connect the CLX Home box to the inverter and the internet (safely behind a firewall,without configuring the latter).• Install the Danfoss SolarApp.• Enter email address and follow the setup procedure described in the Danfoss SolarApp.For details refer to Chapter 2. When these steps are completed, it is possible to start monitoringthe plant from anywhere in the world.Note:All values shown are based on inverter data and are not legally binding.1. Introduction2 L00410618-03_021