Danfoss DHP-A Installation Instructions Manual

Also see for DHP-A: User guide Service instructions User manual Installation and service instructions User manual

Contents

Danfoss DHP-A Installation Instructions Manual Manual pdf 73 page image

6. Adjust the ROOM value so that the reference room reaches your required indoor temperature of 20-21°C.Remember that other rooms will have different temperatures during trimming, but these are adjusted later.7. If the ROOM value must be adjusted more than 3°C upwards or downwards the CURVE value must be adjus-ted instead. See Adjusting CURVE values for more information.8. If the indoor temperature varies several degrees despite trimming, a specific part of the heat curve mayneed adjusting. Check at what outdoor temperature the variation is greatest and adjust the curve at thecorresponding value (CURVE 5, CURVE 0, CURVE -5). See Adjusting a specific part of the heat curve for moreinformation.9. When the reference room has an even temperature of 20-21°C over a 24 hour period, you can adjust theradiator valves in the other rooms so that their indoor temperatures are the same temperature or lowerthan the reference room.10.9 Customer informationAfter commissioning is complete, the customer must be informed about their new heat pump installation. Belowis a checklist regarding the information that the installer must give the customer:• The model of the heat pump that has been installed• Run through the User manual and show what it contains• Describe the various operating modes and what they mean• Describe the most common alarms and corrective actions• Demonstrate how to navigate the control system and which settings the customer can set themselves• Demonstrate how to view history and operating times• Show the pipe installation and go through the periodic maintenance actions that the customers must beaware of:o check the recommended pressure on the manometerso fill the heating systemo exercise safety valveso clean strainers• Explain how the customer can tune their existing heating system according to the instructions in the Usermanual• The applicable warranties• Where the customer is to turn for servicing• Finally, fill in the references at the back of the Maintenance instructions.Installation instructions VMBMA1002 – 71

/ 74

Related manuals for Danfoss DHP-A