Menu selection Meaning FactorysettingBRINE OUT Shows the actual temperature for brine out. -POOL Only appears if POOL is selected. Shows the actual pool temperature. The set pool temperature isshown in brackets.-COOLING Indicates temperature.SHUNT GROUP Only appears if SHUNT GROUP is selected. Shows the actual supply temperature. The calculated supplytemperature to the shunt group is within brackets.-2ND HEAT CIR. Shows the temperature of the second heating circuit if installed by the buffer tank system.CURRENT Only appears if CURRENT LIMITER is selected. Shows the actual current consumption. The set value forMAX CURRENT is shown in brackets.-8.5 Sub-menu OPERAT.TIMEMenu selection Meaning Factory settingHEAT PUMP Compressor operating time for both heating and hot water production. -AUX. HEAT 1 OPERAT. TIME AUX. HEATER 1. -AUX. HEAT 2 OPERAT. TIME AUX. HEATER 2.AUX. HEAT 3 OPERAT. TIME AUX. HEATER 3.HOT WATER Operating time for hot water with compressor. -COOLING Operating time cooling.ACT COOLING Operating time active cooling.8.6 Sub-menu DEFROSTMenu selection Meaning Factory settingDEFROSTS Total number of defrosts carried out. -BETW. 2 DEFR The operating time of the compressor in minutes between the two last defrosts. -TIME LAST DEFR The operating time of the compressor in minutes since last defrost. -FAN H OFF AT High speed is deactivated at this temperature and low speed is activated. 12°C(range: 10°C / 20°C)DEFROST CURVE Used to change the angle of the defrost curve using + or– (Change the start temperaturefor defrost).-10°C(range: -13°C / -7°C)MANUAL DEFR Used to perform a manual defrost. Started using + or -. 0(range: 0 / 1)8.7 Sub-menu LANGUAGEMenu selectionSVENSKAENGLISHDEUTSCHNEDERLANDSFRANÇAISESPAÑOLITALIANONORSKDANSKSUOMIEESTIInstallation Guide Domestic heat pumpsDanfoss Heating Solutions VMGFQ102 41