Mechanical dimensions, E EnclosuresFrame size E1 E2450-600 hp [315-450 kW](380-480 V)500-750 hp [355-560 kW](525-600 V)450-600 hp[315-450 kW](380-480 V)500-750 hp[355-560 kW](525-600 V)IPNEMA21Type 1254Type 1200ChassisCardboardbox sizeShippingdimensionsHeight 33.1 in [840 mm] 33.1 in [840 mm] 32.7 in [831 mm]Width 86.5 in [2197 mm] 86.5 in [2197 mm] 67.1 in [1705mm]Depth 29 in [736 mm] 29 in [736 mm] 29 in [736 mm]Drivedimensions Height 78.7 in [2000 mm] 78.7 in [2000 mm] 59 in [1499 mm]Width 23.6 in [600 mm] 23.6 in [600 mm] 23 in [585 mm]Depth 19.5 in [494 mm] 19.5 in [494 mm] 19.5 in [494 mm]Max weight 690 lbs [313 kg] 690 lbs [313 kg] 611 lbs [277 kg]3.4. Mechanical InstallationPreparation of the mechanical installation of the adjustable frequency drive must be done carefullyto ensure proper results and to avoid additional work during installation. Start by taking a closelook at the mechanical drawings at the end of this instruction manual to become familiar with thespace demands.3.4.1. Tools NeededTo perform the mechanical installation, the following tools are needed:• Drill with 0.39 or 0.47 in [10 or 12 mm] drill.• Tape measure• Wrench with relevant metric sockets (7-17 mm)• Extensions to wrench• Sheet metal punch for conduits or cable glands in IP 21 and IP 54 units• Lifting bar to lift the unit (rod or tube Ø 0.75 in [20 mm]) able to lift minimum 880 lbs[400 kg].• Crane or other lifting aid to place the adjustable frequency drive in position• A Torx T50 tool is needed to install the E1 enclosure in IP 21 and IP 54 enclosure types.VLT® HVAC DRIVE High PowerInstruction Manual 3. How to InstallMG.11.F1.22 - VLT® is a registered Danfoss trademark. 213