Danfoss HVAC Drive FC 102 Series Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

2.1.7 Analog Input Commands (Acknowledged)VLTResponseCommand Subcom-mand Region NPA Objectno.AttributeNo. Attribute Message Type CommentsACK 1 - 1 0-23 1 Byte Read AnalogInputRead Object Configuration attributeassociated with each individual pointACK 1 - 1 0-23 2 Byte Read AnalogInput1) Read Object Status attributeassociated with each individual pointACK 1 - 1 0-23 3 Float Read AnalogInput2) Read Analog Input Value attributeassociated with each individual pointACK 1 - 1 0-23 8 Float Read AnalogInputRead Low Alarm attribute associatedwith each individual pointACK 1 - 1 0-23 9 Float Read AnalogInputRead Low Warning attribute associ-ated with each individual pointACK 1 - 1 0-23 10 Float Read AnalogInputRead High Warning attribute associ-ated with each individual pointACK 1 - 1 0-23 11 Float Read AnalogInputRead High Alarm attribute associatedwith each individual pointACK 1 - 1 0-23 12 Float Read AnalogInputRead Differential attribute associatedwith each individual pointACK 2 - 1 0-23 1 Byte Write AnalogInputWrite to Object Configuration attrib-ute associated with each individualpointACK 2 - 1 0-23 8 Float Write AnalogInputWrite to Low Alarm Limit attributeassociated with each individual pointACK 2 - 1 0-23 9 Float Write AnalogInputWrite to Low Warning Limit attributeassociated with each individual pointACK 2 - 1 0-23 10 Float Write AnalogInputWrite to High Warning Limitattributeassociated with each individual pointACK 2 - 1 0-23 11 Float Write AnalogInputWrite to High Alarm Limit attributeassociated with each individual pointACK 2 - 1 0-23 12 Float Write AnalogInputWrite to Differential attribute associ-ated with each individual pointACK, noaction 7 2 1 0-23 - Float OverrideAnalog inputsAnalog inputs are "outputs" from thefrequency converter and should notbe written over by the networkcontrollerACK, noaction 7 3 1 0-23 - - OverrideAnalog ReleaseAnalog inputs are "outputs" from thefrequency converter and should notbe written over by the networkcontrollerACK, noaction 7 7 1 0-23 - -Write AnalogInput Attrib-utesOptional command for slave devices.Only used for N2commissioning purposesInstructions VLT® Metasys6 MG.11.G2.02 - VLT® is a registered Danfoss trademark22