Danfoss PVE 7 Series Service Manual

Also see for PVE 7 Series: Technical information

Contents

Danfoss PVE 7 Series Service Manual Manual pdf 15 page image

Mounting of Replacement1. Avoid contamination - also oil in connectors.2. Avoid harming LVDT pin.3. Depending on PVB – actuator orientation place one or all bolts in actuator bolt holes.4. Reassure that O-rings are in place on actuator.5. Place actuator on PVB and screw bolts lose and clockwise.6. Tighten bolts to torque indicated in instruction.7. Connect wiring.Test and use of PVG and ActuatorAfter replacement of actuator the system must be tested after manufactures guidelines.After service the PVG must be tested according to manufactures guidelines. Ensure that safety functionsand performance apply to demands.Before restart bleed system. PVG can be bleed through PVM. Let application run for In worst cases airmust be washed out by oil in up to 5 minutes activation.Returning Replaced Actuator for Customer ClaimsIf replaced actuator is returned to Danfoss for analysis description of malfunction and application mustbe submitted too. See form in section “returning claims”.Service ManualPVE Series 7Exchanging PVE© Danfoss | August 2017 AX00000348en-US | 0101 | 15

/ 16

Related manuals for Danfoss PVE 7 Series