Danfoss PVE Series 4 Technical Information

Also see for PVE 4 Series: Installation guide

Contents

Danfoss PVE Series 4 Technical Information Manual pdf 7 page image

Standards for PVE• International Organization for Standardization ISO 13766 Earth moving machinery - Electromagneticcompatibility.• EN 50014:1997 +A1, A2: 1999• EN 50028: 1987. For ATEX approved PVE‒ IEC EN 61508‒ ISO 12100-1 / 14121‒ EN 13849 (Safety related requirements for control systems)‒ Machinery Directive 2006/42/EC” (1st Edition December 2009)PVE with connector variantsHirschmann/DIN variant Deutsch variant AMP variantWarningsPlease work through all warnings before implementing actuators in any application. The list of warningsmust not be seen as a full list of potential dangers. Depending on application and use other potentialdangers can occur.Warnings are listed next to the most relevant section and repeated in a special section at the end oftechnical data. See Product warnings for more information.W WarningAll brands and all types of directional control valves – including proportional valves – can fail and causeserious damage. It is therefore important to analyze all aspects of the application. Because theproportional valves are used in many different operation conditions and applications, the machinebuilder/ system integrator alone is responsible for making the final selection of the products – andassuring that all performance, safety and warning requirements of the application are met.PVE series 4 introductionPVE Series 4 is the common name for the Danfoss PVG electrical actuator. This technical informationcovers our voltage controlled PVE and our current controlled PVHC actuator. For the PVHC please see inthe PVHC sectionl. The digital actuators PVED-CC and PVED-CX are covered in their special technicalinformation.Technical Information PVE, Series 4 for PVG 32/100/120 and PVHCGeneral Information520L0553 • Rev GD • Jan 2014 7