Danfoss RX1 Installation Instructions Manual

Also see for RX1: Installation instructions Instructions Installation instructions

Contents

Danfoss RX1 Installation Instructions Manual Manual pdf 10 page image

10GB - Commissioning InstructionsThermostat (refer to page 3 for thermostat type)Step 1. Type A Press & hold buttons W and + for 3 secondsType B Press & hold LEARN button for 3 secondsType C Remove dial, press & hold LEARN button for 3seconds (located under setting dial)Do not replace knob until Learn process is completeNOTE: Thermostat now transmits continuously for 5 minutes.ReceiverStep 2. RX1Press and hold buttons PROG and CH1 for 3 secondsuntil green light flashesStep 3. RX2 / RX3 (if applicable)Stat 1 - perform steps 1-2 for CH1Stat 2 (RX2 & RX3)Wait 5 mins, perform step 1, then pressPROG + CH2 on RX2/RX3Stat 3 (RX3 only)Wait 5 mins, perform step 1, then pressPROG + CH3 on RX3Use onlyduringprogrammingReceiver statusLED, flashes whenreceivingEmergency ‘ON’ button, pressif communication fails, turnson heat, returns to AUTO whencommunication is re-established.Zone statusLEDs, lit when‘ON’Commissioning InstructionsGB