Danfoss VLT AutomationDrive FC 300 Programming Manual

Also see for VLT AutomationDrive FC 300: Instruction manual Operating instructions Design guide Service manual Operating instructions

Contents

Danfoss VLT AutomationDrive FC 300 Programming Manual Manual pdf 20 page image

2.1.14 Infinitely Variable Change of NumericData ValueIf the chosen parameter represents a numeric data value,select a digit with the [◀] [▶] navigation keys.130BP073.10635 RPM1 - 71 Start Delay00.0s0.44 A 1 (1)1- 7*Start AdjustmentsChange the selected digit infinitely variably with the [▲] [▼]navigation keys.The chosen digit is indicated by the cursor. Place the cursoron the digit you want to save and press [OK].130BP072.10957RPM1-71 High starting torque time0. s11.58A 1 (1)1-7*Start Adjustments42.1.15 Value, Step-by-StepCertain parameters can be changed step by step or infinitelyvarying. This applies to 1-20 Motor Power [kW], 1-22 MotorVoltage and 1-23 Motor Frequency.The parameters are changed both as a group of numericdata values and as numeric data values infinitely varying.2.1.16 Read-out and Programming ofIndexed ParametersParameters are indexed when placed in a rolling stack.15-30 Fault Log: Error Code to 15-32 Alarm Log: Time contain afault log which can be read out. Choose a parameter, press[OK], and use the [▲] [▼] navigation keys to scroll throughthe value log.Use 3-10 Preset Reference as another example:Choose the parameter, press [OK], and use the [▲] [▼]navigation keys to scroll through the indexed values. Tochange the parameter value, select the indexed value andpress [OK]. Change the value by using the [▲] [▼] keys. Press[OK] to accept the new setting. Press [CANCEL] to abort.Press [Back] to leave the parameter.2.1.17 How to Programme on the NumericalLocal Control PanelThe following instructions are valid for the Numerical LCP(LCP 101).The control panel is divided into four functional groups:1. Numerical display.2. Menu keys and indicator lights - changingparameters and switching between displayfunctions.3. Navigation keys and indicator lights (LEDs).4. Operation keys and indicator lights (LEDs).Display line: Status messages displaying icons and numericvalue.Indicator lights (LEDs)• Green LED/On: Indicates if control section is on.• Yellow LED/Wrn.: Indicates a warning.• Flashing red LED/Alarm: Indicates an alarm.LCP keys[Menu] Select one of the following modes:• Status• Quick Setup• Main MenuHow to Programme FC 300 Programming GuideMG.33.MB.02 - VLT® is a registered Danfoss trademark 192 2