Danfoss VLT AutomationDrive FC 302 Instruction Manual

Also see for VLT AutomationDrive FC 302: Service guide Programming guide Instruction manual Installation guide Operating guide

Contents

Danfoss VLT AutomationDrive FC 302 Instruction Manual Manual pdf 50 page image

[Off]Stops the connected motor (when pressed on theadjustable frequency drive LCP) or the filter (when pressedon the filter LCP). The key can be [1] Enabled or [0]Disabled via 0-41 [Off] Key on LCP. If no external stopfunction is selected and the [Off] key is inactive, the motorcan only be stopped by disconnecting the line powersupply.[Auto On]Enables the adjustable frequency drive to be controlled viathe control terminals and/or serial communication. When astart signal is applied on the control terminals and/or thebus, the adjustable frequency drive starts. The key can be[1] Enabled or [0] Disabled via 0-42 [Auto on] Key on LCP.NOTICE!An active HAND-OFF-AUTO signal via the digital inputshas higher priority than the control keys [Hand On] –[Auto On].[Reset]Is used for resetting the adjustable frequency drive or filterafter an alarm (trip). The key can be [1] Enabled or [0]Disabled via 0-43 [Reset] Key on LCP on the LCP. ResetThe parameter shortcutCan be carried out by holding down the [Main Menu] keyfor 3 seconds. The parameter shortcut allows direct accessto any parameter.5.1.3 Changing Data1. Press [Quick Menu] or [Main Menu].2. Use [▲] and [▼] to find parameter group to edit.Changing data3. Press [OK].4. Use [▲] and [▼] to find parameter to edit.5. Press [OK].6. Use [▲] and [▼] to select correct parametersetting. Or, to move to digits within a number,use [◄] and [►]. The cursor indicates the digitselected to be changed. The [▲] key increases thevalue, the [▼] key decreases the value.7. Press [Cancel] to ignore the change, or press [OK]to accept the change and enter a new setting.5.1.4 Changing a Text ValueIf the selected parameter is a text value, change the textvalue by using the [▲]/[▼] keys.[▲] increases the value, and [▼] decreases the value. Placethe cursor on the value to be saved and press [OK].130BP068.10740RPM0 -01 Language[0] English10.64 A 1 [1]0-0*Basic SettingsFigure 5.13 Display Example5.1.5 Changing a Group of Numeric DataValuesIf the selected parameter represents a numeric data value,change the selected data value pressing the [◄] and [►]navigation keys as well as [▲] and [▼] keys. Press [◄] and[►] to move the cursor horizontally.130BP069.101- 6*113 RPM 1.78 A 1(1)Load depen. setting1 - 60 Low speed loadcompensation1 00%Figure 5.14 Display ExamplePress [▲]/[▼] to change the data value. [▲] enlarges thedata value, and [▼] reduces the data value. Place thecursor on the value to be saved and press [OK].130BP070.101 - 60 Low speed loadcompensation1 0%Load depen. setting 1- 6*729RPM 6.21A 1(1)6Figure 5.15 Display ExampleUser Interface Instruction Manual48 Danfoss A/S © Rev. 2014-02-07 All rights reserved. MG37A22255