5 Relay terminals (drive module)Illustration 23: Serial Communication, Digital Input/Output, Analog Input/Output, and Relay Terminals Cross-reference5.6 Split Shipment Wiring Harnesses5.6.1 Connecting Wiring HarnessesContext:Procedure1. Connect the wiring harnesses according to how the enclosed drive is split. Each wiring harness in the enclosed drive is labeled.Refer to the illustrations in this section for label names and descriptions.A Connect the fan supply wiring harness.B Connect the thermal protection harness.C If applicable, connect the PHF contactor harnesses.D If applicable, connect the cabinet heater harness.2. Connect the output filter cables. Refer to the illustrations in this section.- For the sine-wave filter option, there is 1 set of cables for each sine-wave filter. One end of each cable is already connected to thefilter, the other end is bundled in the sine-wave filter cabinet. Connect the unattached sine-wave cable ends to the motor terminalsinside the drive cabinet.- For the dU/dt filter option, the unattached filter cables are bundled inside the dU/dt filter cabinet. Connect the unattached cableends to the motor terminals within the drive cabinet.3. Connect the input filter cables. Refer to the illustrations in this section.- For the passive harmonic filter (PHF) option, the filter cables are bundled inside the input filter cabinet. First connect theunattached PHF cable ends (R/S/T) to the corresponding terminals in the input power options cabinet. Then connect theunattached PHF cable ends (L1R/L2S/L3T) to the R/S/T terminals in the drive cabinet.- For the line reactor option, the line reactor cables are bundled inside the input filter cabinet. First connect the unattached linereactor cable ends (R/S/T) to the corresponding terminals in the input power options cabinet. Then connect the unattached linereactor cable ends (L1R/L2S/L3T) to the R/S/T terminals in the drive cabinet.Electrical InstallationOperating Guide | VLT® HVAC Drive FC 102AQ262141314214en-000101 / 130R0880 | 49Danfoss A/S © 2018.10
