Page 18 of 31about the DNA5K4 control panel, click the “?” in the right-hand corner of the DNA5K4control panel in PodWare.Amplifier ChannelsIt is important to realize that each two channel amplifier section contains its’ own DSP. Soa four channel amplifier is logically split into two sections, each with two channels. Thereis an independent two channel control panel associated with each section. Each sectionwill appear in PodWare as an independent ‘device’ in the Network Tree.The Tree will add the Device Name with the Role Number for each of the sections insquare brackets. The Role Number 1 section is for Channels 1 and 2, and Role Number 2for channels 3 and 4.The descriptions of the PodWare control panel therefore relate to a 2-channel section.The amplifier has two and two or four outputs. There is not necessarily a 1:1correspondence between inputs and output because the routing between inputs andoutputs may be changed; either by you or by the amplifier vendor (see the HiddenControls section for more details). For example, one input may be used to feed twooutputs.User ControlsThe control panel for the DSP amplifier allows the parameters to be viewed and adjusted.The panel may have one of two different formats: A monitoring panel (the ‘MonIcon’)where the status of the amplifier may be viewed, or a full control panel where all thecontrols to adjust parameters are located. The full panel has a ‘tabbed’ area which allowsyou to choose from a number of different areas of interest.There are some controls such as mute, which are displayed constantly; the remainingparameter controls being organised into tabbed groups depending upon function.Monitoring Section (MonIcon)This allows you to view what is going on inside the amplifier at a glance. There are inputsignal level meters showing the input signal level on each input, signal level meter(s) foreach output which indicate signal level relative to the limiter setting for each output, athermal meter giving an impression of the temperature inside the amplifier, an amplifier