Dansons Group CC2 Owner's Manual
Also see for CC1: Operation guide
                                     | |
Copyright 2005 29 Vulcan V SERIES Owner’s ManualCanadian Comfort Industries www.stovesunlimited.com Dansons Group Inc.PERIODIC M AINTENANCESOOT - FLY ASH:The by products of combustion contain small particles of fly ash. Fly ash will collect in the exhaust venting systemand restrict the flow of flue gases. Incomplete combustion, (such as during startup) shutdown or incorrect operationof the room heater will lead to some sort of soot formation which will collect in the exhaust system. Because of thisit is important that the exhaust system be inspected and cleaned at least once a year to determine if cleaningis needed. It is a good practice to inspect after every 1–2 tons of pellet fuel burning.With proper cleaning and the use of quality pellets, your VULCAN F22 appliance requires very littlemaintenance. However, the following periodic maintenance is strongly recommended. This should bepreformed seasonally, bi-seasonally, or every 1-2 tons of fuel usage.WARNING: Unplug your stove's electrical cord prior to opening the sides of the stove or opening the exhaustsystem for any inspection, cleaning, maintenance or service work.NEVER perform any inspections, cleaning, maintenance or service on a HOT STOVE.ASH TRAPS: [COLD STOVE ONLY] Remove the back plate from the firebox area. This will expose thetwo ash traps and the fuel drop shute. Fly ash may be removed by vacuuming inside the trap areas. It is alsogood to use a brush (bottle cleaner) to reach up and down to scrape the build up off the metal areas.BURN GRATE: Periodically remove and clean your grate. In particular it is advisable to clean out theholes to remove any build up that may prevent air from moving through grate freely. If grate has becomeplugged with hard residue from burning lower quality fuel, you may need to use a sharp awl or drill bit toopen holes back to their original size.BURN POT: This is the “pot” where the pellets are burned in the grate. When removing your grate forcleaning, check the burn pot area for ash build up. Some ash will fall through the grate holes and build upunder the grate. This needs to be cleaned out to prevent lack of air flow through the burn grate.DOOR GASKET: Inspect the main door gasket periodically. The main door may be removed tohave frayed, broken or compacted gaskets replaced by your Authorized VULCAN F22 Dealer.FAN MOTORS: Clean the in-take on CONVECTION (ROOM AIR) fan as well as the air holes onthe motors of both COMBUSTION and CONVECTION fans annually. Disassemble the COMBUSTIONAIR FAN and clean out the internal fan blades as part of your fall start up.FRESH AIR INTAKE: Inspect periodically to be sure that it is not clogged with any foreign materials. Aplugged screen will restrict or shut off combustion air and cause a fire to die or burn poorly.GOLD / BRASS / NICKEL /PEWTER TRIM CLEANING: Use a damp cloth to clean yourdoor. DO NOT USE ANY ABRASIVE CLEANERS AS YOU WILL REMOVE OR SCRATCH THEPLATING!CHECK AND CLEAN THE HOPPER :Check the hopper periodically to determine if there is any sawdust or pellets that are sticking tothe hopper surface. Clean as needed.RIODICGLASS (High Temp, Neo-Ceram): We recommend using a high quality glass cleaner. Should abuild up of creosote or carbon accumulate you may wish to use 000 steel wool and water to clean glass.Ceramic is very hard and will not scratch from the steel wool.GLASS REPLACEMENT: In the event you need replacement only Neo-Ceram of the correct size andthickness may be used. Contact your local VULCAN F22 dealer to obtain this glass.DO NOT OPERATE STOVE WITH BROKEN GLASS AS LEAKAGE OF FLUE GASES MAY RESULT. |
Related manuals for Dansons Group CC1
manualsdatabase
Your AI-powered manual search engine