Dantherm CDF 10 Service Manual

Also see for CDF 10: Manual Service manual

Contents

Dantherm CDF 10 Service Manual Manual pdf 12 page image

102. Installation of the unit2.1 Suspension of the CDF 10 unitThe wall suspension bar supplied with the unit is fixed to the wall and the dehumidifier is hung up on it. It isimportant to mount the unit in a horizontal position to secure correct outflow of the condensate water.The dehumidifier must be placed in a way that allows unimpeded air intake through the front and outlet through thegrill on the sides. Be sure always to leave at least 100 mm free space around the unit for optimum operation.It is important that the dehumidifier is not installed near a source of heat as for example a radiator, and doors andwindows must be kept closed when the dehumidifier is in function.2.2 Condensate outletThe condensate outlet is located at the bottom of the dehumidifier. The unit has a drain spigot intended forconnection of a ½’’ flexible or fixed water connection. If water drain through the wall is chosen, a suitable hole ismade in the wall and the condensate hose is led out through this hole, before suspending the dehumidifier on thewall suspension bar.As an alternative a condensate pump can be fitted at the water outlet to pump the water to a drain.The placing of the condensate outlet is shown on the drawing below.NOTE! On the rear of the unit a cable binder protects the compressorduring transport. This cable binder must be removed beforesuspension and power connection.