Darex XT3000i Operator's Manual
                                                           | |
Contents
| 
223. Pull wheelguard coveraway fromwheel.4. Using a 4 mmhex key,remove 3;5mm sockethead capscrews(PP16318FF)& split washer (PP08650FF)from grindingwheel retainer.5. Remove thewheel retainer6. Pull wheeltoward youthen to theright and out ofthe machinecavity.7. Clean the machine cavity as well as themounting hub and wheel beforereinstalling.8. Repeat steps in reverse to install newwheel.NOTE: Because the Darex grinding wheelcannot be trued it is critical that the motor hub &wheel register be cleaned. Once wheel has beeninstalled, rotate the wheel by hand to check thatthe wheels run true. If not, loosen the screws ,reposition the wheel and tighten the screws.Separating grinding wheel from point splitwheelThe grinding and pointsplit wheel are piggybacked and boltedtogether. To changeany one of the wheelsyou must firstseparate them. Youcan access the boltsfrom the back side ofthe sharpening wheel.1. Using a 5mmhex key, removethe 3; 6mmsocket head capscrews(PP16348FF) &split washers.(PP10282FF)2. The two wheels can now be separated.RecalibratingMaterial RemovalAfter a wheel change, verifyand/or recalibrate materialremoval.Use a 3/8 HSS standard twist drill, measure thelength of drill before sharpening.1. Rotate material removal knob to maximumtake off.2. Align drill as thoughyou intend tosharpen it. FollowAlignment steps onpage 11.3. Once drill is set tolength, alignedand captured inWheel Information |
Related manuals for Darex XT3000i
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine