Dart MD10P Instruction Manual
                                | |
Contents
| 
14Software ParametersParameter DescriptionValue Range(units)FactoryDefault0 Selecting this item exits to Running Mode n/a n/aRead-Only Parameters1 Model Number 10 – MD10P Unit11 – MD3P Unit13 – MD3E Unit10, 11, or132 Software Build 1 – 9999 n/a3 Hardware Version 1 – 9999 n/a4 Serial Number – Major (reserved) n/a n/a5 Serial Number – Minor (reserved) n/a n/aGeneral Setup10 Operating Mode 1 – Rate Mode2 – Time Mode3 – Follower Mode111 Display Intensity 0 – 31 (Dim – Bright) 2013 Decimal Point Position 0 – DP Disabled (XXXX)1 – X.XXX2 – XX.XX3 – XXX.X4 – XXXX.014 Keypad Mode 1 – Linear, Constant Rate2 – Non-linear, Accelerating Rate215 Keypad Scroll Delay 0 – 30 (Fast – Slow) 1016 S1 / S2 Input Edge & Prescaler Configuration 0 – S1 is Rising/1 S2 is Rising/11 – S1 is Falling/1 S2 is Rising/12 – S1 is Falling/4 S2 is Rising/13 – S1 is Falling/16 S2 is Rising/14 – S1 is Rising/1 S2 is Falling/15 – S1 is Falling/1 S2 is Falling/16 – S1 is Falling/4 S2 is Falling/17 – S1 is Falling/16 S2 is Falling/18 – S1 is Rising/1 S2 is Falling/49 – S1 is Falling/1 S2 is Falling/410 – S1 is Falling/4 S2 is Falling/411 – S1 is Falling/16 S2 is Falling/412 – S1 is Rising/1 S2 is Falling/1613 – S1 is Falling/1 S2 is Falling/1614 – S1 is Falling/4 S2 is Falling/1615 – S1 is Falling/16 S2 is Falling/16018 Power-up Mode 1 – Default to Zero Display2 – Default to Power-up Value3 – Default to Previous Running Val.319 Power-up Value 0 – 9999 (Display Units) 0Display & Control Loop Setup20 Display Minimum 0 – 9998 (Display Units) 021 Display Maximum 1 – 9999 (Display Units) 240023 Accel Setting 1 – 9999 (Display Units) 250024 Decel Setting 1 – 9999 (Display Units) 250026 Proportional Gain 0 – 9999 (Not Unit-specific) 027 Integral Gain 1 – 9999 (Not Unit-specific) 500029 Pulse Accumulation Limit 2 – 5000 (Not Unit-specific) 15Signal Input #1 (S1) Setup30 S1 Display Reference 0 – 9999 (Display Units) 240031 S1 Reference RPM 0 – 9999 (RPM) 240032 S1 Pulses per Revolution 1 – 2048 (PPR) 133 S1 Deadband (Follower Mode Only) 0 – 1000 (Seconds) 0UserSettings |
manualsdatabase
Your AI-powered manual search engine