DataCard SP55 Plus Printer Manual

Also see for SP55: Supplementary guide Installation guide Brochure & specs

Contents

DataCard SP55 Plus Printer Manual Manual pdf 28 page image

Page 25Site requirementsOperating environment• Relative humidity: 20% to 80% non-condensing• Temperature: 60° F to 95° F (15° C to 35° C)Electrical requirements• The external power supply is rated at 100-240 VAC, 50-60 Hz,1.8 amp. (It adjusts to any power within this range.)• Single phase, 3-wire, grounded receptacle only.Physical requirements• The printer weighs less than 11.5 pounds (5.3 kg). The weightdepends on the supplies and options installed.• Printer dimensions are 21.5 inches (546 mm) long and 7.8inches (198 mm) wide. The 100-card input hopper is 9.5 inches(241 mm) high and the 200-card hopper is 11.9 inches (302 mm)high.• The clearance required 1 inch (25 mm) at the back, 2 inches (5cm) on the left side, and 10.5 inches (267 mm) above the printerlatch to open the cover.Do not use the printer in a dirty environment. Do not use the printerin a closed compartment. Do not block air flow around the printer.9.5”11.9”10.5” (for cover)7.8”2”1”21.5”

/ 30

Related manuals for DataCard SP55