51RAID SETTINGSTo setup the RAID Standby Timer Settings and RAID Rebuild Priority Settings,please complete using the following steps:1. Under the last sub-menu (bottom), select to go into the RAID Settings.Write in the amount of minutes preferred under “Please enter a valuebetween 0 and 10922 (minutes)” for RAID Stand-by Timer Settings. Onceset, after idling for the specified minutes, the RAID disks will enter into thestand-by mode.2. Adjust the slider bar under “Please select a value from the slider” by goingleft or right. Left side indicate “low” and right side indicate “high” for speedof rebuilding and will affect the speed of data transfer based on setpreference. The higher the RAID Rebuild Priority, the quicker the rebuildspeed, and the slower the data access and transfer speed.3. After entering preferences, click on the “Apply” icon to begin the process.Once completed, a popup window stating “Apply the RAID standby timersettings successfully. Apply the RAID rebuild priority settings successfully”will appear to confirm. Click on the “Ok” icon to re-confirm.