Datacom DM4001 Installation And Operation Manual
                                                       | |
Contents
| 
Chapter 14. Installation Guide1. Insert the SFP transceiver into one of the four switch module bays. There’s only one orientation thatthe module can be plugged. The optical connector should face outward. The slot connector shouldface down for the upper bays, and up for the lower bays.2. Slide the module into the slot and press firmly to ensure it seats into place.Note: Installing or removing a SFP module can be done without powering off the switch. SFPtransceivers are hot-swappable, but make sure there are no network optic cables connected to themodule before removing it!The SFP modules that can be used with DmSwitch and each correspondent maximum cable lenght aredescribed in the table bellow:Table 14-1. Gigabit SFP ModulesSFP Module Fiber Type Maximum Lenght1000BASE-SX multimode 550m1000BASE-LX singlemode 10km1000BASE-LH singlemode 80km1000BASE-LZ singlemode 120kmWarningSignals over fiber optic cables are transmitted via lasers. Although the lasers arecompliant with the requirements of Class 1 Laser Products and are eye safe innormal conditions, never look direclty at a transmit port when it’s turned on!After this, attached the security locker according the figure belowFigure 14-6. Locking the SFP module41 |
Related manuals for Datacom DM4000 ETH12GX+1x10GX-MPLS
manualsdatabase
Your AI-powered manual search engine