DATAKOM DKG-705 User’s Manual705_USER.doc - 21 -6.2 AVR ControlThe voltage matching is controlled by the alternator’s AVR module. The DKG-705 compares themains phase R voltage with the genset phase U voltage.The AVR control output (terminals 43-44) is similar to an isolated variable resistor. Usually allbrands and types of AVR accept an external adjustment potentiometer. The AVR control will use theseinputs, thus the DKG-705 is able to control most of the AVRs found on the market.The impedance range of the AVR output is 300 ohms to 200 K-ohms. The range is adjustable withan internal potentiometer accessible from the back panel of the unit.The functions of the AVR output are controlled by programmed parameters:P_A04 AVR Control Enable: This parameter enables/disables the activation of the AVR control output. IfAVR control is disabled, the output will always stay at the rest level defined by P_A14.P_A05 AVR Reverse Polarity: In normal polarity, the AVR control impedance decreases in order toincrease the alternator voltage. If reverse polarity is selected the AVR impedance increases in order toincrease the alternator voltage.P_A14 AVR Start: This is the rest value of the AVR control impedance. Always set this value to 160 andthen adjust the alternator voltage with the AVR’s control pot. However, if needed, alternator voltageadjustment may be made through this parameter. Do not forget that, if this parameter is modified, theadjustment range will be reduced.P_A16 AVR Gain: This parameter defines the reaction speed of the AVR output to voltage differencesbetween genset and mains phases during synchronization. The standard value for this parameter is 64.But it must be readjusted for the genset during manufacturing. If this parameter is too high, a voltageoscillation may occur. If it is too low, the voltage matching will be slower.