Datalogic DS1100 SH2347 Programming Manual

Also see for DS1100 SH2347: Quick guide Special instructions Reference manual Installation manual

Contents

Datalogic DS1100 SH2347 Programming Manual Manual pdf 15 page image

06656 7Wand Emulation OperationTo operate the PSC scanner in Wand Emulation the user must firstturn off the powerto the host device and then detach the scanner fromthe host device by removing the cable from the scanner.The proper Wand Emulation cable must be connected between thescanner and the portable data terminal for remote data collection. Ifusing an optional Smart Cable, the scanner automatically switches toWand Emulation. Specific Wand Emulation parameters may stillneed to be set. If using a cable without Smart Cable switching, theuser must then configure the scanner to its Wand Emulation mode byscanning the symbol CC.CC Same Code Wand EmulationThis symbol activates the following default parameters:Code Type = Same Code Wand EmulationCode type, bar code polarity, and transmission rate can each be set forWand Emulation. Menu symbols for these parameters are found inthe section on Wand Emulation Parameters.When the user with a Smart Cable again connects to the host device,the scanner will automatically revert to the original communicationmode. Without Smart Cable, scan the appropriate programmingsymbol.CE Enable WedgeCA Enable Serial Mode